Gigabit Surge Protector Injector with Active Protections
Active Surge Protector Injector is a Power over Ethernet injector with integrated surge protection device.
The built-in microprocessor constantly checks the functional parameters and protects actively the connected device against power surges, short-circuits and over voltages.
It can be used as a stand-alone injector or combined with a CMD module, connected through a bus-c cable.
Features
By the means of the lateral selectors you can set the PoE Mode and polarity.
Mode Selector
MODE A+B (Po4P)
MODE B (4,5 / 7,8)
MODE A (1,2 / 3,6)
Polarity Selector
NORMAL POLARITY: + 4,5 e/o 1,2 | – 7,8 e/o 3,6
INVERSE POLARITY: – 4,5 e/o 1,2 | + 7,8 e/o 3,6
Specifications
Highlights
ASPI
surge protector
2
stages tvs-gdt
15
kA peak surge current
A-B
PoE modes
CMD
remote management
LAN
galvanic isolated
1ms
short circuit protection
Operating Voltage
10 – 60 Volts AC/DC
Max Current
1 A (2A in High Power Version)
Power Connector
1.5 mm2 wires terminal blocks
Ethernet Connectors
Shielded RJ45 Jacks
GND Connector
4 mm lug
Power Lines
(Mode B)
+ VDC: Pins 4 & 5 (7 & 8 with inverse polarity) – VDC: Pins 7 & 8 (4 & 5 with inverse polarity)
Power Lines
(Mode A)
+ VDC: Pins 1 & 2 (3 & 6 w ith inverse polarity) – VDC: Pins 3 & 6 (1 & 2 with inverse polarity)
Transmission Speeds
10BaseT; 100BaseT; 1000BaseT
Leds
Status led (blinks if no charge connected), Alarm led (on if injection is disabled), BUS led
Active Protection
Overvoltage control, Overload control, Short Circuit Protection (1ms reaction time)